#!/bin/bash
# Adapted from
# "Using OTG mode on Raspberry Pi SBCs"
# https://pip-assets.raspberrypi.com/categories/685-app-notes-guides-whitepapers/documents/RP-009276-WP/Using-OTG-mode-on-Raspberry-Pi-SBCs

# Is the dwc2 overlay installed?  Nothing will work if it isn't.
LOGGER="systemd-cat -t gadget.sh"
if lsmod | grep -q "dwc2"; then
    $LOGGER -p info "DWC2 module loaded, setting up OTG gadget serial and ethernet"
else
    $LOGGER -p warning "DWC2 module missing.  Aborting OTG setup"
    exit 1
fi


sudo modprobe libcomposite
cd /sys/kernel/config/usb_gadget
# Create our new gadget
sudo mkdir MyGadget
cd MyGadget
# Add some boilerplate data that the gadget needs
echo 0x1d6b > idVendor # Linux Foundation’s USB VID. Replace with your own VID if required
echo 0x0104 > idProduct # Multifunction Composite Gadget
echo 0x0100 > bcdDevice # v1.0.0
echo 0x0200 > bcdUSB # USB2
mkdir strings/0x409 # 0x409 = English
# Insert your own manufacturer and gadget name here
echo "RaspberryPi" > strings/0x409/manufacturer
echo "MyPiGadget" > strings/0x409/product
# Make the serial number the same as the Raspberry Pi serial number; you can use whatever is required here
SERIAL=`cat /proc/cpuinfo | awk '/Serial/ {print $3}' `
echo $SERIAL > strings/0x409/serialnumber
# Create a configuration area and populate
mkdir configs/c.1
echo 120 > configs/c.1/MaxPower
mkdir configs/c.1/strings/0x409
echo "Config 1" > configs/c.1/strings/0x409/configuration

# Create our specific gadget type
## Mass storage device
###  Remember to create the storage block device first
##  cd /root
### Example: Make a 256 MB file to act as "USB stick"
##  sudo dd if=/dev/zero of=drive.bin bs=1M count=256
### Create a VFAT file system on the backing store
##  sudo mkfs.vfat drive.bin
##
# mkdir functions/mass_storage.usb0
## Set up our backing store
# echo "/home/pi/drive.bin" > functions/mass_storage.usb0/lun.0/file
## Link our function to our configuration
#ln -s functions/mass_storage.0 configs/c.1/

## Serial (CDC ACM)
mkdir functions/acm.usb0
ln -s functions/acm.usb0 configs/c.1/

## Ethernet (RNDIS and ECM)
## Of note, this may cause the IP to show up as 127.0.0.1
## and wireless to suddenly fail to connect
mkdir functions/ecm.usb0
ln -s functions/ecm.usb0 configs/c.1/

## USB Device Controller update
UDC=`ls /sys/class/udc`
echo $UDC > UDC