The motor sweeps through the speeds (tested)

lgpio/motor-test.py

@@ -0,0 +1,34 @@
+#!/usr/bin/python
+# This test assumes you are trying to control a motor through a DRV8833 motor
+# controller chip.  This general approach should work for other motors as well.
+import lgpio
+import time
+
+# pin assignments
+gpio_pwm = 18  #MOTA1
+gpio_reverse = 16 #MOTA2
+gpio_notsleep = 24 #MSLEEP
+# parameters
+pwm_freq = 1000
+
+
+h = lgpio.gpiochip_open(0)
+try:
+    lgpio.gpio_claim_output(h, gpio_reverse)
+    lgpio.gpio_claim_output(h, gpio_notsleep)
+    lgpio.gpio_write(h, gpio_reverse, 0)   # low on reverse pin to turn off h-bridge MOTA2
+    lgpio.gpio_write(h, gpio_notsleep, 1)   # high on /sleep to enable both h-bridges
+    
+    while True:
+        for pwm_level in range(0,100):
+            lgpio.tx_pwm(h, gpio_pwm, pwm_freq, pwm_level)
+            pwm_level += 10
+            time.sleep(0.05)
+        for pwm_level in range(100,0,-1):
+            lgpio.tx_pwm(h, gpio_pwm, pwm_freq, pwm_level)
+            pwm_level += 10
+            time.sleep(0.05)
+
+finally:
+    lgpio.gpio_write(h, gpio_notsleep, 1)   # high on /sleep to disable    
+    lgpio.gpiochip_close(h)          # Always close!